A Q A C O M B I N E D S C I E N C E · P H Y S I C S
Charge and Current
Topic 2 Electricity · Lesson 5
A Q A C O M B I N E D S C I E N C E · P H Y S I C S
Charge and Current
Topic 2 Electricity · Lesson 5
Physics Lesson 5 of the GCSE Combined Science series - the first lesson of Topic 2, Electricity. Written for AQA Combined Science Trilogy 8464, sections 6.2.1.1 (Standard circuit diagram symbols) and 6.2.1.2 (Electrical charge and current), Physics Paper 1.
Structure: 01 Hook, 02 Learn, 03 Check (including the Professor), 04 Go Higher (pink HIGHER badge), 05 Apply and Review. Foundation groups can stop before section 04.
The equation Q = I t must be recalled - it is not on the AQA equation sheet.
0 1 / H O O K
You flick a switch and the light comes on instantly. How?
Charges race from the switch at light speed
The wires are already full of charges
The bulb stores up light
Electricity jumps through the air
P H Y S I C S
Take a vote and use the spinner to hear a few reasons.
The wires and the bulb are already full of charged particles (electrons). When the circuit is completed, they all start moving at once, all round the loop - so the bulb lights straight away, even though each electron only drifts slowly. The next slide reveals it.
0 1 / H O O K
The wires are already full of charge!
Close the switch and all the charges round the loop start moving at once.
That flow of charge is an electric current.
Today: circuit symbols, what current is, and how to calculate the charge that flows.
P H Y S I C S
A common analogy is a bicycle chain - push the pedals and the whole chain moves at once.
T O D A Y ' S G O A L S
By the end of the lesson
Foundation
I can recognise and draw the standard circuit symbols.
I can explain that current is the rate of flow of charge.
I can use charge = current × time.
I can explain why the current is the same all round a single loop.
Higher
I can rearrange Q = I t and convert units.
P H Y S I C S
Share the goals. Foundation goals are for everyone; the Higher goal is covered in section 04.
0 2 / L E A R N
Circuit symbols
Scientists everywhere use the same symbols, so anyone can read a circuit diagram.
Draw wires with a ruler, as straight lines.
A variable resistor has an arrow through it - its resistance can be changed.
P H Y S I C S
AQA 6.2.1.1 lists the symbols students must know, including the switch, cell, battery, diode, resistor, variable resistor, LED, lamp, fuse, voltmeter, ammeter, thermistor and LDR. The fuse (a rectangle with a line through it) is not drawn here - add it if your class needs it.
0 3 / C H E C K
Which component does this symbol show?
Resistor
Variable resistor
Thermistor
LDR
Answer: a variable resistor - a resistor with an arrow through it. A thermistor has a bent line through it; an LDR has a circle with two arrows pointing in.
0 2 / L E A R N
What is current?
Current is the rate of flow of electrical charge.
It only flows in a closed loop with a source of potential difference (a cell or battery).
It is measured in amps (A) with an ammeter, connected in series.
P H Y S I C S
AQA 6.2.1.2: "For electrical charge to flow through a closed circuit the circuit must include a source of potential difference. Electric current is a flow of electrical charge." By convention, current flows from the positive terminal round to the negative terminal.
0 3 / C H E C K
Electric current is the rate of flow of...
Charge
Voltage
Resistance
Power
Answer: charge. The size of the current is how much charge flows past a point each second.
0 2 / L E A R N
Calculating charge
charge flow = current × time
Q = I t
Q = charge in coulombs (C) · I = current in amps (A) · t = time in seconds (s)
Worked example: a current of 0.5 A flows for 60 s.
Q = 0.5 × 60 = 30 C
P H Y S I C S
AQA 6.2.1.2: "The size of the electric current is the rate of flow of electrical charge." Students must recall Q = I t. 1 amp means 1 coulomb of charge passes each second.
0 3 / C H E C K
A current of 2 A flows for 10 s. How much charge flows?
5 C
12 C
20 C
0.2 C
Answer: 20 C. Q = I t = 2 × 10 = 20 coulombs. 5 C divides 10 by 2; 12 C adds them. Image credit: Joanna Kosinska / Unsplash
0 2 / L E A R N
Current in a single loop
In a single closed loop, the current is the same at every point.
Charge is not used up by the lamps - the same charge flows all the way round and back to the battery.
So every ammeter shows the same reading.
P H Y S I C S
AQA 6.2.1.2: "A current has the same value at any point in a single closed loop." What the lamps transfer is ENERGY, not charge - that idea comes with potential difference in Physics 6.
0 3 / C H E C K
One ammeter in a single loop reads 0.4 A. What does another in the same loop read?
0 A
0.2 A
0.4 A
0.8 A
Answer: 0.4 A - the current is the same at every point in a single loop. Lower readings suggest charge is used up, which it is not.
Drag each fact to the right quantity
CHARGE (Q)
CURRENT (I)
TIME (t)
Measured in seconds (s)
Measured in coulombs (C)
Measured with an ammeter
Measured in amps (A)
Measured with a stopwatch
What flows round the circuit
P H Y S I C S
Charge (Q): measured in coulombs (C); what flows round the circuit. Current (I): measured with an ammeter; measured in amps (A). Time (t): measured in seconds (s); measured with a stopwatch.
T H E A N S W E R S E X P L A I N E D
How did we get those?
Symbol: a resistor with an arrow through it is a variable resistor.
Current: the rate of flow of charge.
Charge: Q = I t = 2 × 10 = 20 C.
Single loop: the current is the same everywhere, so the other ammeter also reads 0.4 A.
P H Y S I C S
Go through all four after the votes.
0 3 / C H E C K
"The lamps use up the current - so less current comes back to the battery than leaves it!" Is the Professor right? Explain.
T H E P R O F E S S O R S A Y S . . .
P H Y S I C S
The Professor's misconception, as an open question - students type their answers. He is clutching his flask.
He is wrong. Current is the flow of charge, and charge is not used up - every charge that leaves the battery comes back to it. In a single loop the current is the same at every point, so the ammeter after the lamps reads the same as the one before. What the lamps transfer is energy, not current.
Look for: "current is the same everywhere in a loop", "charge is not used up", "the lamps transfer energy, not charge".
T H E A N S W E R E X P L A I N E D
Sorry, Professor!
Current is a flow of charge, and charge is not used up.
Every bit of charge that leaves the battery comes back to it.
In a single loop the current is the same everywhere - before and after the lamps.
The lamps transfer energy, not current.
P H Y S I C S
Go through this after students have typed their answers. Energy and potential difference are the focus of Physics 6.
Charge and current recap
Current is the rate of flow of charge. It is measured in amps with an ammeter connected in series. Charge is measured in coulombs. Charge = current × time. In a single closed loop the current is the same at every point, because charge is not used up.
P H Y S I C S
A recap of the Foundation section. "Smaller" tests the Professor's misconception.
S P E C C H E C K
Your exam spec
Circuit symbols and Q = I t are in every specification.
AQA Combined Science Trilogy (8464) - 6.2.1.1 Circuit symbols and 6.2.1.2 Charge and current, Physics Paper 1.
Edexcel Combined Science (1SC0) - Topic 10 Electricity and circuits: Q = I × t.
OCR Gateway Combined Science (J250) - Electricity: charge, current and circuit symbols.
CCEA Double Award Science (NI) - Physics: electric circuits, charge and current.
P H Y S I C S
A variant slide for classes on other specifications. Some boards give Q = I t on an equation sheet; AQA expects it to be recalled.
Delete this slide if your class only sits AQA.
0 4 / G O H I G H E R
Rearranging Q = I t
I = Q ÷ t · t = Q ÷ I
Units first: minutes → seconds (× 60). Milliamps → amps (÷ 1000): 250 mA = 0.25 A.
Worked example: 120 C of charge flows in 2 minutes. What is the current?
t = 2 × 60 = 120 s → I = Q ÷ t = 120 ÷ 120 = 1 A
P H Y S I C S
HIGHER
Higher slide. Rearranging equations is a Higher maths skill, and unit conversion is where most marks are lost. Remind students to write the equation before substituting.
0 4 / G O H I G H E R
How long does it take for 60 C of charge to flow at 0.5 A?
HIGHER
30 s
60.5 s
120 s
0.008 s
Answer: 120 s. t = Q ÷ I = 60 ÷ 0.5 = 120 s. 30 s multiplies instead of dividing; 0.008 s divides the wrong way round.
0 4 / G O H I G H E R
300 C of charge flows in 1 minute. What is the current?
HIGHER
0.2 A
5 A
300 A
18000 A
Answer: 5 A. 1 minute = 60 s; I = Q ÷ t = 300 ÷ 60 = 5 A. 300 A forgets to convert minutes to seconds; 18000 A multiplies.
T H E A N S W E R S E X P L A I N E D
How did we get those?
Time: t = Q ÷ I = 60 ÷ 0.5 = 120 s. Dividing by 0.5 doubles the number.
Current: convert first - 1 minute = 60 s. Then I = Q ÷ t = 300 ÷ 60 = 5 A.
Check the units before you calculate: seconds and amps.
P H Y S I C S
HIGHER
Talk through both Higher answers.
0 5 / A P P L Y & R E V I E W
Exam practice
Question
A current of 3 A flows through a lamp for 20 s. Calculate the charge that flows. Give the unit. [3 marks]
Working space
Model answer
Key takeaway
Charge = current × time.
P H Y S I C S
FOUNDATION
Foundation exam question. The unit mark is independent - award it even if the number is wrong.
0 5 / A P P L Y & R E V I E W
Exam practice
Question
A phone charger supplies a current of 500 mA. How long does it take to transfer 1800 C of charge? [3 marks]
Working space
Model answer
Key takeaway
Convert mA to A first.
P H Y S I C S
HIGHER
Higher exam question. Allow error carried forward for the third mark if the conversion is wrong but the method is right.
These are model points in the style of an AQA mark scheme, not an official mark scheme.
0 5 / A P P L Y & R E V I E W
Exit ticket: why is the current the same at every point in a single loop?
P H Y S I C S
Exit ticket. Good answers: current is the flow of charge; charge is not used up by components, so the same amount of charge passes every point each second.
Great work, scientists!
Next physics lesson - Physics 6, Potential difference and resistance.